Microcell Recoil Pad Black 23mm Thick *GRIND TO FIT*

This is an Italian made Microcell recoil pad these are a very lightweight and extremely good at reducing felt recoil. This one is 150mm long 50mm wide and 23mm thick with 80mm hole spacing.

microCell  is the new generation recoil pad by Cervellati srl, produced in an expanded technopolymer. Compared to the traditional pads in rubber or in gel, microCell offers the following advantages:

• microCell  is  50-60%  lighter;
• significantly  higher recoil absorption;
• minimal deformation during the shot;
• no   “bottom   out”   effect   over  time

These recoil pads are extremely well made, and well finished, and would grace the stock of any gun no matter it’s manufacture, and look fantastic.

Grinding Instructions

1. For perfect adherence,  flatten the stock’s  back  and wrap  the stock  to protect it during the process.

2. Lubricate  the   screws,  then   plug   them   in   the   original   holes   on   the  stock.

3. To grind the toe end of microCell pad,  it is necessary to use a high speed machine. We  recommend   to employ  a   400 grit sanding belt   for finish.   Best results can be achieved by the use  of a new  and lubricated belt.

4. Finally, during the grinding,   the stock  should  be gently drawn  close to the belt. This will avoid overheating and damaging the recoil pad.