Paper Bulls Eye Targets 300 x 420mm

Product Description

Paper Targets - Bullseye with grid.

Features

Ideal for sighting in Rifles at 100m

High definition large size paper targets.

Dimensions: 300mm x 420mm

Your rifle should be shot from a well-padded rest, under calm wind conditions, resting forearm, not barrel on pad.

Bore sight your rifle, then place target close at 25M, test fire to make sure the bullets land on the target. Then place target at desired distance to sight in.

Four Steps to sight in your scope using the Grid on the target

1.      Locate on the chart the exact centre of at least three carefully fired shots, using the same hold and sight setting. For example, suppose the centre of group is small circle in the upper right hand quarter of the chart, identified by the arrow..

2.      Following the vertical line we come to the figure 3L. This means that to bring the next group onto the vertical centre line requires that you move your rear sight 3 MOA to the LEFT. If your sight reads in MOA this means you must give it 3 clicks to the LEFT. If in ½ MOA, 6 clicks and if in ¼ MOA, 12 clicks.

3.      Now follow the horizontal line to the edge of the chart and we come to the figure 3D. This means you must move DOWN the sight 3 minutes-of-angle to bring your next group onto the horizontal centre line.

4.      If your aim was steady and correct on the first group and no puff of win blew any of your shots out of the group, your next group should be in and around the 10 ring. Your rifle is then sighted in for the range and ammunition used.

NOTE: Changing your sight 1 MOA changes where the bullet strikes ½ inch at 50 yards, 1 inch at 100 yards, 1 ½ inches at 150 yards and 2 inches at 200 yards. Fire your group carefully, and let the rifle cool for a few minutes between groups.

Front-Page-Tab-Boots-Category